USB connection issue with new Mac install - LightBurn Software

They aren’t setting those numbers, that’s just echoing the values stored in the controller. This is how LightBurn knows the maximum: Typing manual S values would require you to be in the correct mode. You’d need to type G1 with a feed rate first, like G1 F100, and then you can use M3 and set an S value. If you aren’t in G1 mode, the S values are ignored because the “spindle” isn’t running during G0 moves, only G1.

Documentation/Using_a_Camera.md at master · LightBurnSoftware/Documentation · GitHub

Laser connection - OS Specific - LightBurn Software Forum

Setting Up The Software – sculpfun

Laser Software – 主站

LightBurn Bridge Kit with Rhodolite Red Heatsink Case – smokeandmirrors

USB connection issue with new Mac install - LightBurn Software Questions - LightBurn Software Forum

Lightburn laser software for Boxford CO2 Laser Cutters

YoraHome 10 Things You Should Know About LightBurn Software - YoraHome Blog

Arducam 8MP Autofocus USB Camera, IMX179 USB 2.0 Lightburn Camera with Microphone, Ultra HD Embedded USB Camera for PC and Raspberry Pi, Compatible with Linux, Windows, and Mac OS : Electronics

Ventura Updated]'An error occurred while installing the selected updates.